Scratching lath pad - assembly manual
1 arrange the end caps symmetrically to each other, with rounded edges in the same plane
2 install the end caps of the lath, pressing them firmly until they stop.
3 screw the screw 5-25mm into the seats of the lath to a depth of the lower plane of the head 8 mm from the surface of the lath
4 detach from the Velcro tape sewn to the mat, strips of tape with hooks img2
5 remove the protective film from the back adhesive side of the Velcro strip with hooks
6 stick a strip of Velcro with hooks to the scratching lath according to the picture img1
a) two strips of Velcro tape with hooks 280 mm long are glued on the back side of the scratching lath at a distance of 1-3 mm from the fastening screws
b) two strips of Velcro tape with hooks 80 mm long are glued on the front side at a distance of 5 mm from the end cap at the top and bottom
7 stick a mat with Velcro tape to lath as shown in the picture img3:
8 stick the long side of the mat to the tape with hooks on either side of lath against the screws
9 wrap the mat around the scratching lath, and stick the opposite side of the mat to the corresponding one strip with hooks against the screws
10 on this assembly of the lath pad for scratching is completed